Along with rare earth magnets (as detailed in my previous post), I’m also beginning to realise that springs (particularly the compression-type) also have a place in the woodworking workshop.
Above, I’ve fitted a 75mm long compression spring between the two M16 nuts on the depth stop for my recently-purchased ED16B pillar drill. I’m sure I made it clear before that I was a little disappointed with this arrangement when I first purchased the machine. Finger-tight pressure between the two nuts was not enough when running the drill on one of the higher speeds – they always vibrate loose so, you have to use a spanner (or, preferably, two). But, with this spring (and a couple of M16 washers) now in place, that’s all in the past. Now, I can easily set the drilling depth without having to reach for a tool – my thanks go to Mike Garnham for this solution.