Part 2 is my Picket Planters video series is now online. It starts off with more machining and ends with all the mortises having been cut on my benchtop, cast-iron hollow chisel mortiser.
In Part 3, I’ll begin by round-topping all the pickets and posts on the bandsaw and, after that, I’ll looking at cutting the tenons on the ends of each rail.
Thanks for viewing.
Over the weekend, I made further progress on the bench seat repair and started by preparing all my previously sawn stock down to finished dimensions.
When I’m working with timber that’s been at least partially sawn on a circular saw, which leaves a much cleaner finish than most bandsaw blades, I find it helpful to scribble over the sawn faces to void confusion later. Unless your planer knives are razor-sharp, it can sometimes be tricky to distinguish the prepared face and edge from the two other surfaces… On a few occasions, yes, I have made the mistake of referencing off the wrong face and edges when feeding stock through a thicknesser! 😳
Continue reading “Bench Repair (Part 2)”