For this window-mirror, I wanted to use rectangular glazing that would complement the functional window that this construction is likely to be situated across the room from. Looking around at various packs of glass tiles and they only appeared to come in square sizes. For a while, I was tempted to buy a pack of mirrored-acrylic tiles from a seller on eBay, knowing they can be cut with woodworking equipment.
Looking around some more and I found Ikea’s Lots mirror tiles and, for the quantity I required, they were set to work out at around half the cost of the acrylic, even before postage. So, after collecting three packs from Ikea in Bristol, I was left with the challenge of having to cut the glass myself – all of which is detailed below.
Continue reading “Making a Window Mirror (Part 2)”
Even though I finished the folding desk last week, I’d like to go back briefly in this post and look at a few areas that I haven’t already included. This was partly because I feared that my posts would become too long but actually, it had more to do with the fact that these photos which were ‘cut’ from the final edit were actually taken on my old camera, which leaves images in a different folder to my new camera’s recordings, on the SD card.
Continue reading “Folding Desk Follow-Up”
Last weekend’s time in the workshop felt very similar to the weekend before, where I basically made a table enclosure, in to which a chest freezer could be tucked safely away. This time though, it was all about preparing myself for another workshop project that’s just over the horizon – for which, I’ll need to safely support and cut down some sheets of 18mm plywood…
It all started with with these scraps of ex. 7x2in treated pine; left overs from the ceiling joists I installed earlier this year. And, just like the Saturday before, most of my time was spent cutting notches out on my sliding compound mitre saw.
Continue reading “Sheet Goods Support Frame”
Tired of turnbuttons? Looking for a new method of fastening a table top securely to a frame while, at the same time, allowing it to happily expand and contract across its width? If so then, you may find the following video interesting, which I found earlier; courtesy of Fine Woodworking magazine:
Sorry, you’ll have to click this link until I can figure out how to embed this one in WordPress…
Thanks for looking. Enjoy! 🙂