Closing Holes

While on Friday I set about correcting the sagging wall unit in my kitchen, Saturday morning was partially spent filling a couple of large holes between cabinets. When I say ‘holes’, I’m actually referring to the vacant spaces that can sometimes be found between wall cabinets. Personally, if I was designing a kitchen, I’d try to exclude them, even where the can be used to run services (pipes an wires).

In my experience, they’re a trap for cobwebs and a flue for downwards draughts that aren’t welcome in winter. That’s why I decided to look at enclosing them.

Continue reading “Closing Holes”

Router Table Design

Earlier this week, I did say that I was going to buy a sheet of 18mm MDF today for the floor-standing router table I was going to begin building this weekend…

Well, I haven’t been able to get as much done on the design-front and, until I’m more certain of the finished dimensions of some of the components, I’m a little cautious of ordering a sheet and having it cut to size – to fit in the back of my van and also, to make life a bit easier handling it at the workshop.

Still, I’d like to share where my design is in its current state, after a brief moment of play in Google SketchUp last night.

Continue reading “Router Table Design”