Part 2 is my Picket Planters video series is now online. It starts off with more machining and ends with all the mortises having been cut on my benchtop, cast-iron hollow chisel mortiser.
In Part 3, I’ll begin by round-topping all the pickets and posts on the bandsaw and, after that, I’ll looking at cutting the tenons on the ends of each rail.
Thanks for viewing.
Last week, I officially moved in to my new home [away from the workshop!] – and that’s no April Fools joke! All this moving around and finishing off all the niggling jobs around the house that weren’t completed have left me with the bare minimal of time to spend back at my ‘real‘ home, in the workshop. Before all this chaos started though, I did at least manage to knock together a simple storage rack for sheet materials, with a few spare hours spread out across one weekend. Yes, the workshop improvements are very much still on-going!
Continue reading “Sheet Material Storage Rack”
Along with rare earth magnets (as detailed in my previous post), I’m also beginning to realise that springs (particularly the compression-type) also have a place in the woodworking workshop.
Above, I’ve fitted a 75mm long compression spring between the two M16 nuts on the depth stop for my recently-purchased ED16B pillar drill. I’m sure I made it clear before that I was a little disappointed with this arrangement when I first purchased the machine. Finger-tight pressure between the two nuts was not enough when running the drill on one of the higher speeds – they always vibrate loose so, you have to use a spanner (or, preferably, two). But, with this spring (and a couple of M16 washers) now in place, that’s all in the past. Now, I can easily set the drilling depth without having to reach for a tool – my thanks go to Mike Garnham for this solution.
Continue reading “Spring Forward”