In an effort to get back in to the swing of regularly updating this blog, I’d like to share with you a design idea that I came up with over Christmas. I may not have been active in the workshop but, I did keep my pencil and sketchbook busy, in order to try and scratch at that woodworking ‘itch’. Without further ado, here is my coffee table concept:
Having officially finished the suspended floor now, I’ve taken a little bit of time to film this short, ‘silent’ video-tour of my workshop in its current state, before I’ve really had a chance to start clearing off the shelves, removed the two floor-standing units and, generally, reshuffled everything around for better optimisation of my current space.
As you’ll see in the video, there’s still a lot of work to be done before I can get back to some proper woodwork again! Hopefully, most of this will have been resolved by the time I come to release a second video-tour, in a couple of weeks.
…Yes, there is a little irony in the title of the song playing on the radio! 😀
All comments welcome.
Thanks for reading – and for watching!
With the 7x2in joists all cut to length, ends re-sealed and ready to fall in to place, my next job was to set out the positioning and spacings for each of the sixteen hangers (eight on either side) and then, to fit them in to place. Below, you can see a mock-up of what I needed to achieve, where the joist must sit 32mm (1¼in) higher than the wall plates, in order to clear the existing truss-frame by a good 5mm, which had already begun to deflect where I’ve previously used it, in appropriately, to store goods (it’s only 4in/100mm deep and is riddled with woodworm, you see).